Инструкции Пользователя для Viper LCD 2_Way

1-W

Button Auto Lock

When On, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked, a
fault tone is emitted. To unlock the buttons; press the

button followed

by the

button, the buttons unlock and tones play to conﬁrm.

Car Select

Car 2

must ﬁrst be turned On (See Remote Features menu under Pro-

gramming). Press and hold the

button for 3 seconds. The remote

ﬂashes the LED and beeps once or twice to indicate the selected Car
is 1 or 2, release the button for Car Select or continue to hold for
programming.

Release the

button, then press and release while the LED and

beeps continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.

Programming

To enter: Press and hold the

button for 8 seconds, the remote emits

one long beep and turns the LED on, the programming main menu has
been accessed (see the following “Remote Features menu”).
To exit: Press and release the

button once, then press and hold the

button again. 1 short and 1 long beep is emitted for each step

back, the LED turns off when programming is exited.

1. Remote Features menu
After entering the programming mode: Press and hold the
button, 2 LED ﬂashes and beeps indicate the remote features
menu is accessed and can be set. Press buttons indicated below,
1beep and ﬂash turns the feature on, 2 beeps and ﬂashes turns
the feature off.
• Autolock feature: Press

to turn on/off.