Справочник Пользователя для Symmetricom XLi IEEE 1588

1

F100 provides two groups of commands: 

•

Group 1, available through the keypad/display and the command line, provides access to 

network port settings and hardware/Firmware status information.

•

Group 2, available through the command line only, provides commands for changing system 

firmware, changing SNMP parameters, changing the user name/password, resetting the unit, 
and pinging other network devices. 

Warning: The F100 commands have the capacity to remove the XLi from the network and disable the 
XLi’s system firmware. Use judiciously.

Reboot Warning: Saving changes to any F100 parameter using the keypad/display will reboot the XLi. 
Some of the F100 command line commands also reboot the XLi. These are identified in the following 
documentation.

You can use both the keypad/display and the command line interface to access the following 
parameters:

•

Ethernet address: XLi contains a unique Ethernet or Media Access Control (MAC) address 

comprised of a unique number assigned to the manufacturer, and a unique number assigned to 
the unit. This is factory set and cannot be changed.

•

IP Address: Sets a static Internet Protocol (IP) address for the unit. 

•

Subnet Mask: Sets a valid subnet-mask used in IP addressing. Subnetting allows for the more 

efficient allocation of network addresses and management of network traffic.

•

Default Gateway: The address of the router that handles packets addressed to IP devices 

outside the local-area network.

•

10 100 BASE-T: The network port bandwidth setting, 10 Base-T or AUTO. (10 Base-T only for 

earlier XLi hardware).

•

Remote Lockout: Enables or disables remote access through the XLi’s standard network port. 

Enabling Remote Lockout limits users to the front-panel keypad or Serial I/O port.

•

Flash CRC: Status - Passed or failed.

•

RAM: Status - Passed or failed.

•

Serial: Status - Passed or failed.

•

Version Test: Status - Passed or failed