Справочник Пользователя для StarTech.com Serial ATA Hard Drive Docking Station UNIDOCK2U

3

Hardware Installation

Plug the power and USB cable from the rear side of the hard 

1. 

drive dock to a power outlet and the USB port on the computer 
respectively.
If connecting a SATA hard drive, simply insert the drive, into the top 

2. 

loading slot on the hard drive dock.  Make sure the connectors on 
the hard drive face the same corner as the cut-out in the drive slot 
door.  
If connecting a 3.5” IDE hard drive, attach the short IDE ribbon cable 

3. 

and the separate LP4 molex power connector to the front side of the 
hard drive dock.  Then attach the 3.5” hard drive to the IDE cable 
and LP4 connector. 
 
If using a 2.5” IDE hard drive with 44-pin connector, attach the 
included 40-pin to 44-pin ribbon cable with integrated LP4 connector 
to the front of the hard drive dock.  Then attach the 2.5” hard drive to 
the ribbon cable.
Once the hard drives(s) are connected, press the power button on 

4. 

the top of the docking station.
The hard drive(s) should be automatically detected by the operating 

5. 

system.

Driver Installation

Windows 2000/XP/Vista/7, Mac OS 9.2 or later or Linux
No driver installation is required for these operating systems, as 
this hard drive dock is natively supported, so the drivers are already 
installed.