Справочник Пользователя для Star Trac E SERIES BIKES E- RB 8110

SSTAR

 

TRAC

 

E

 

SERIES

 

BIKES

 

OWNER’S

 

MANUAL 

15 

Your Star Trac Bike will be shipped with the display in a separate carton.  This section covers the final assembly of the 
LED display.  If you ordered a Personal Viewing System (PVS) or an embedded computer, please refer to the separate 
assembly instructions included with those products

 

Open the separately packaged display and remove the M4 screws from 
the back plastics, set these aside for additional use.  Attach the rear 
display cover to the display weldment with four M4 screws and four M4 
washers included with the display. 

 

 

 

 

 

 

 

Position the front half of the display plastic in 
front of the display weldment. 

 The 

following 

display 

connections will need to be 

made. 

A.

Connect the main display cable with a white 9 
pin connector to the J4 connector on the 
display PCB. 

B.

Connect the contact heart rate cable to the 
heart rate board 

C.

Ground wire from the heart rate board must 
be connected to the quick disconnect tab on 
the display weldment. 

D.

Ground wire from the base frame should be 
connected to the 2

nd

 quick disconnect tab on 

the display weldment. 

 

NOTE:  For the LED display the coax cable is not used and should be replaced into the main neck tube. 

 

 

 

 

With the electrical connections made you can now attach the display.  Next you 
will need to attach the front of the display to the weldment.  First guide the 
bottom of the display under the front tabs of the weldment and then second you 
will need to pivot the display forward around the tabs to mate front display 
plastic to the rear plastic that is attached to the weldment. 

 

Once in place attach the plastics with the M4 screws included with the display. 
There are 8 M8 screws that attach around the perimeter of the display, secure 
properly. 

 

A

B

Quick Disconnect 
Ground Tab