Справочник Пользователя для Smarthome Stud Sensor 2421

 

(Antenna not 

shown for clarity) 

Used by TriggerLinc to detect whether the included magnet is 
within ½ inch of the main case: 

•  Reed switch is in the closed state when the magnet is 

inside ½ inch 

•  Reed switch is in the opened state when the magnet is 

further than ½ inch  

When the jumper is installed (default), TriggerLinc will send an 
INSTEON ON command when it opens and an OFF command 
when it closes. When the jumper is uninstalled (as in Multi-
Scene Mode), TriggerLinc will activate Scene 1 when it opens 
and activate Scene 2 when it closes.  

NOTE: When installing or uninstalling the jumper, the battery will 
need to be removed and then reinstalled for the new jumper 
setting to take effect.  

Used to: 

•  Link to other INSTEON devices (Responders) 
•  Control Linked Responders (Scene 1): tap to toggle 

between on and off 

When using an external sensor, TriggerLinc is in the closed state when either  the external sensor 
terminals or the reed switch are closed. In other words, TriggerLinc opens when both the external sensor 
terminals and reed switch are open. See Advanced Use of External Sensors with TriggerLinc  for more 
information. 

Indicates: 

•  Change in state (opens or closes) 
•  TriggerLinc is in Linking/Unlinking Mode (Status LED is blinking)  

Arrows indicate the location of the reed switch inside the main case, so the magnet should be installed as 
close as to them as possible. 

Included magnet is installed on opposing plane than TriggerLinc main case. It should be less than ½ inch 
away from the main case when the door/window, etc. is closed and further than ½ inch when open.  

Page 5 of 12