Справочник Пользователя для Smarthome NSTEON KEYPADLINK 2486D
INSTEON KeypadLinc V2 Dimmer User’s Guide
Setting the X10 On-Level and X10 Ramp Rate for the X10 Primary Address
When an X10 Controller sends an X10 ON or X10 OFF
command to KeypadLinc Dimmer’s Primary X10
Address, the Local On-Level and Local Ramp Rate
apply. In other words, KeypadLinc Dimmer acts the
same way as it would if you manually tapped its On
Button or Off Button.
command to KeypadLinc Dimmer’s Primary X10
Address, the Local On-Level and Local Ramp Rate
apply. In other words, KeypadLinc Dimmer acts the
same way as it would if you manually tapped its On
Button or Off Button.
NOTE
If you want an X10 On-Level and Ramp
Rate other than the Local values, you can
set up one or more X10 Scene Addresses
as described in the sections Remotely
Setting an X10 Scene Address and On-
Level and Remotely Setting the Ramp Rate
for an X10 Scene Address below.
Rate other than the Local values, you can
set up one or more X10 Scene Addresses
as described in the sections Remotely
Setting an X10 Scene Address and On-
Level and Remotely Setting the Ramp Rate
for an X10 Scene Address below.
See the section HOW TO SET UP ON-LEVELS AND
RAMP RATES, above, for instructions on setting up the
Local On-Level and Local Ramp Rate.
RAMP RATES, above, for instructions on setting up the
Local On-Level and Local Ramp Rate.
Enabling and Disabling Resume Dim
If Resume Dim is enabled, KeypadLinc Dimmer will remember the last brightness level to which it was
set. Then, when an ON command is received from a controller, or the load is turned on from the
KeypadLinc, the light will go to the remembered brightness, rather than to the preprogrammed level.
Resume dim function is not available if an X10 address is assigned.
set. Then, when an ON command is received from a controller, or the load is turned on from the
KeypadLinc, the light will go to the remembered brightness, rather than to the preprogrammed level.
Resume dim function is not available if an X10 address is assigned.
To enable Resume Dim, set up a Local On-Level of OFF (or zero). To disable Resume Dim, set up a
Local On-Level of anything but OFF.
Local On-Level of anything but OFF.
See the section HOW TO SET UP ON-LEVELS AND RAMP RATES, above, for instructions on setting up
the Local On-Level.
the Local On-Level.
Page 26 of 38