Справочник Пользователя для Skylink MULTI LINK PRO ML-001

OPERATION

Note:
- Each zone can program up to 2 sensors. There are 5 zones, so up to 10 sensors
can be programmed to the control panel. Please refer to page 37, "Sensor
Location Selection Guide" for detail information.

Alert Mode Examples (Door/Window sensor sold separately)

Note:
-For Door / Window sensor, alert notification (beeping and LED flashing) will
continue until the sensor is in closed position, i.e. closing the window or door.

-For Motion Sensor, the alert notification (beeping and LED flashing) will last for 20
seconds for every detected movement.

The Control Panel is always in one of the 2 operating modes:

1. Alert Mode - When the system is not armed (ARM LED off), it is in alert mode.
2. Alarm Mode - When the system is armed (ARM LED on), it is in alarm mode.

The Control Panel will be in alert mode automatically if the system is not armed.
Alert mode allows users inside the premises to know what sensor is triggered.
It is intended to be used when someone stays inside the premises.

In alert mode, the control panel will give you notification of the triggered sensor(s)
by voice announcement, unique beeping and LED flashing.

Number of beeps

Zone of the triggered sensor

Number of flashes of zone LED

Sensor number of the triggered sensor

Voice announcement

Tells you the zone and locations of
the triggered sensor by human voice.

Alert Mode

3. Double flash

Zone 3
Sensor 2
Triggered

3. Single flash

Zone 1
Sensor 1
Triggered

2.
Beep___Beep___
Beep___Beep .....

Zone 1 Sensor 1
door open

Zone 3 Sensor 2 window
open

2.
Beep Beep Beep___
Beep Beep Beep___

–

ADVANCED PROGRAMMING

Zone 1

SENSOR 1

Button [1]

SENSOR 2

Zone 2

Zone 3

Zone 4

Zone 5

Button [2]

Button [3]

Button [4]

Button [5]

Button [6]

Button [7]

Button [8]

Button [9]

Button [0]

This row

Buttons for
Sensor 1

Zone LED :
Flash once

This row

Buttons for
Sensor 2

Zone LED :
Flash twice

Erase Sensors

Proceed to the following to erase a sensor.

[PROG]
[MPIN]

Enter
Programming
mode

Enter master
password to
programming mode

3 beeps for valid password.
1 long beep for invalid
password.

[9]

Select erase
remote
programming

After [9] is entered, some
zone LEDs will flash or
stay off. The zone LEDs
represent whether that zone
is occupied by any sensor.
**See Table D below.

Refer to the table
below to select the
remote location.

Select the
sensor you
would like to
erase

After you have  selected the
sensor, you will hear 3 beeps
and verbal confirmation
[Zone X Sensor Y Empty
Memory], where X and  Y
are the zone and sensor
numbers you have  selected.

To erase an
occupied
sensor, press
[1] to [0].

ZONE LED

DESCRIPTION

Off

Zone is not occupied by any sensor

Flashes once

This zone is occupied by sensor 1.

Flashes twice

This zone is occupied by sensor 2.

Flashes once,

This zone is occupied by sensors 1 and 2.

then twice

** Table D: Zone LED status for erasing sensors.

Step

Keys

Function

Description

Note

–