Справочник Пользователя для Simrad AP25

Simrad AP25 Autopilot 

96

 

20221495F

 

 

The display will read ‘SETUP 
REQUIRED’. 
Continue with the installation setup 
according to the next chapters. 
If you already have completed the 
installation settings, the autopilot 
will enter STBY mode. 

Note ! 

The installation settings must be performed as part of the 
installation of the AP25 system. Failure to do so correctly may 
prohibit the AP25 from functioning properly! 
The Installation menu can only be accessed in STBY mode. 
The Installation Settings are grouped into the following 
functional categories: 
•  Language:  

Selection of language used for display 

 information 

•  Dockside: 

Items to be set prior to sea trials 
These will vary depending on the type of 
feedback the autopilot will use (page 67, 100, 
109) 

•  Interface: 

Setting the format of the clock/data output for  

  

radars connected to the Autopilot Computer. 

•  Display units:  Setting the units to be displayed for wind 

  

speed, water temperature and depth. 

•  Sea trial: 

Presents settings and automatic calibrations to 

  

be performed during sea trial. 

•  Parameters: 

Permits viewing and changing of basic 

  

steering parameters (See also Response 

  

control, page 56). 

•  Service: 

System data, NMEA data, NMEA test, 

  

SimNet setup, Master reset of memories. 

Each group is designed to focus on specific functions, and enable 
quick access when changes need to be made.