Справочник Пользователя для Sapphire Audio DV425TR

02/01                                                                                     Page 13                                                                               250-5533

KIT CONTENTS:  Replacement orifice (fits top 

vent models only); replacement pilot injector.

TOOLS REQUIRED:  Power drill (a 90° handle is 

helpful); #2 Phillips bit; 5/32" Allen wrench; 5/8" open 

end wrench.

 1.  Remove front (if installed), glass, and logs (if 

installed.)

 2.  Remove log/burner pan: First remove screws 

then lift the front of pan vertically and slide pan to 

one side and pull out of firebox. Fig. 1

 3.  Remove burner plate.

 4.  Pull off pilot hood and set aside.  Fig. 2

5.  Use a 5/32" Allen wrench to remove the pilot 

injector. Fig. 3

 5.  Replace pilot injector with the one supplied in the 

conversion kit (#35 for Propane, #62 for Natural 

Gas).   

NOTE: The injector is ONLY replaced if you are con-

verting to another gas. It is not replaced for a 

change from top to rear vent.

 6.  Replace pilot hood, snapping into position.

 7.  Remove main burner orifice using a 5/8" wrench.

 8.  Replace orifice with the proper size as indicated 

below for your gas type and venting: Fig. 4

 

 

Top Vent:  .063 (52 DMS)  .106 (36 DMS)

Rear Vent:  .059 (53 DMS)  .096 (41 DMS)

 See next page for Valve Regulator Replacement:

MILLIVOT GENERATOR

PILOT HOOD

THERMOCOUPLE

Pilot Hood