Справочник Пользователя для Sapphire Audio DV425TR

02/01                                                                                     Page 44                                                                               250-5533

 

The gas line must be installed in accordance 

with all local codes, if any; if not, follow ANSI 223.1 

and the requirements listed below.  

 

The stove and gas control valve must be 

disconnected from the gas supply piping during any 

pressure testing of that system at test pressures in 

excess of 1/2 psig.  For pressures under 1/2 psig, 

isolate the gas supply piping by closing the manual 

shut-off valve.

 

The appliance must be isolated from the gas 

supply piping system by closing its equipment shutoff 

valve during any pressure testing of the gas supply 

piping system at test pressures equal to or less than 

1/2 psi (3.5 kPa).

 

Leak test all gas line joints and the gas control 

valve prior to and after starting the stove.

 

This unit is manufactured  for use with  natural 

gas.  To convert to LP gas, Part #844-9010 LP 

Conversion Kit, is required and available through your 

dealer

 

Before making the gas connection, ensure 

that the stove you are installing is designed for the 

type of gas being supplied.  This information can be 

found on the Ratings Label on the back of stove.  If 

the stove has been converted to propane (LP), the 

valve cover will have a label stating that the unit has 

been converted to propane.

 

Connect the gas line at the 3/8” pipe 

connector on the valve at the back of stove.  See 

illustration on the next page.  We recommend 

connecting the stove with an approved flex gas line.  

If flex gas lines are not approved in your area, you 

cannect a hard pipe to the gas hookup.  

 

You must supply a manual shutoff valve in a 

visible location within 3’ (914mm) of the stove.

 

After running new gas line, or if a gas line has 

been disconnected, purging of the gas line may be 

necessary.  To purge gas line, open the inlet pressure 

tap and allow gas to flow through while carefully 

monitoring for the odor of either natural gas, which 

will rise, or propane, which will settle near the 

floor.  As soon as you smell the gas, discontinue 

purging the line.  Ensure that the room has plenty 

of ventilation and that no sparks or open flames 

are near the end of the gas line during the purging 

process.  Do not try to ignite the stove until any and 

all gas accumulation has been cleared from the room.