Справочник Пользователя для Rimage Auto Printer RAS10

- 

Important: To prevent errors, the carousel should be installed before operating the software 
or powering on the AutoPrinter. 

1. Slide 

the 

carousel into the unit so that 

the shaft slides in the slot opening of 
the bearing guide. 

2.  Lower the carousel with the top 

support bearing dropping in to the 
bearing guide. 

3.  If necessary, rotate the carousel to seat 

the carousel securely.  

 

 

 

 

The carousel must be installed before you power on the system. For more information about 
installing the carousel, refer to Installing the carousel on page 5. 

 

Note: The Prism printer power switch must be in the ‘on’ position. The Everest printer does 
not have a power switch. The Everest printer is powered on when the AutoPrinter is powered 
on.  
The Everest printer takes 1 to 2 minutes to complete the initialization. 

 

1.  To power on the AutoPrinter, press the power 

switch on the rear of the AutoPrinter. 

2.  To power off the AutoPrinter, press the power 

switch. 

110656_H  

5