Справочник Пользователя для Proxim AP-4000

Other Network Settings

Perform the following command to enable or disable DHCP Relay Agent Status.

[Device-Name]>set dhcprelaystatus enable

Perform the following command to configure and enable a DHCP Relay Server. The AP allows the configuration of a 
maximum of 10 server settings in the DHCP Relay Agents server table.
[Device-Name]>set dhcprlyindex 1 dhcprlyipaddr <ip address> dhcprlycmt <comment> 
dhcprlystatus 1 (1 to enable, 2 to disable, 3 to delete, 4 to create)

[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1–5 (depending on what table row you wish to address)> 
              ipaddr <ip address of the host computer you want to check>
[Device-Name]>set linkintpollint <the interval between link integrity checks>
[Device-Name]>set linkintpollretx <number of times to retransmit before considering the 
link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (to confirm new settings)
[Device-Name]>reboot 0

See 

 for information on the parameters listed below. The AP-4000/4000M/4900M uses index 3 for Wireless 

Interface A (802.11a radio) and index 4 for Wireless Interface B (802.11b/g radio).

[Device-Name]>set wif <index> mode <see table>

ACS is enabled by default. Reboot after disabling or enabling ACS.

[Device-Name]>set wif <index> autochannel <enable/disable>
[Device-Name]>reboot 0

1

dot11b-only

2

dot11g-only

3

dot11bg

4

dot11a-only

5

dot11g-wifi

6

publicsafety