Справочник Пользователя для PROLINK Huricane 9200/S

Скачать
Страница из 205
 
Chapter 
12
. Configuring Network Address Translation  
 
 
131
 
5.  In the Global Address From and Global Address To fields, 
type the starting and ending addresses that identify the pool 
of public IP addresses that the private addresses should be 
translated to. Or, type the same address in both fields (if you 
also specified a single address in step 4). 
6.  Follow steps 8-11 under "The NAPT rule" on page 125 to 
submit your changes. 
@
,
+
#
""
Like the Basic flavor, the Filter flavor translates public and private IP 
addresses on a one-to-one basis. The Filter flavor extends the 
capability of the Basic rule. Refer to “The Basic Rule” on page 130 
for a general description. 
You can use the Filter rule if you want an address translation to 
occur only when your LAN computers initiate access to specific 
destinations. The destinations can be identified by their IP 
addresses, port type (which identifies it as a FTP or Web server, for 
example), or both. 
Figure 54 shows the fields used to establish a Filter rule. 
 
Figure 54. NAT Rule
Add Page (Filter Flavor)  
 
Follow these instructions to add a Filter rule (see steps 1-4 under 
"The NAPT rule" on page 125 for specific instructions 
corresponding to steps 1 and 2 below): 
1.  Display the NAT Rule – Add Page, select 
FILTER
 as the 
Rule Flavor, and enter a Rule ID. 
2.  Select the interface on which this rule will be effective.