Справочник Пользователя для PROLINK Huricane 9200/S

Скачать
Страница из 205
 
Chapter 
19
. Configuring Autodetect  
 
 
185
 
,
%
"
Follow these steps to configure Autodetect: 
1.  Log into Configuration Manager, click the Admin tab and 
then click 
)
"
to display the Autodetect page: 
 
Figure 87. Autodetect Page 
 
2.  Select the appropriate Autodetect mode of operation, as 
described in the previous section, from the Autodetect Mode 
drop-down list. 
3.  Click the Enable radio button. 
4.  Click 
A page will display briefly to confirm your changes. Autodetect 
will not start searching for a valid connection until the modem is 
rebooted. 
5.  Click 
A warning message will display to inform you that the current 
configuration will be lost. 
6.  Click 
The modem will reboot and the Web interface will be temporarily 
unavailable. Upon reboot, Autodetect will begin searching for a valid 
VC and will create a PPP, an EoA, or an IPoA interface on your 
modem corresponding to the type of interface detected on the 
access server. You can monitor the success or failure of the 
Autodetect process by displaying the System Log page, located in 
the Admin tab. 
If you disable Autodetect, be sure to commit your changes. Also, 
when Autodetect is disabled, you must manually configure ATM VC 
information as described in “Configuring the ATM VC” on page 56.