Справочник Пользователя для PROLINK Huricane 9200/S

Скачать
Страница из 205
 
Chapter 
6
. Configuring the System Operating Modes 
 
 
81
 
The sections that follow describe common system configurations 
that use bridging, routing, or both. 
Note that you can also configure several special
 
operating modes. 
These are described in ”Configuring Special Bridging Features” on 
page 84
.
 
@
"
*
In this scenario, the ISP requires customers to have a routed 
connection to their access server. For a routed connection, the LAN 
and WAN interfaces must be IP-enabled. No bridging services need 
to be enabled. This configuration would have these features: 
  An Ethernet (and/or USB) interface with an IP address and 
network mask that identify it as being in the same subnet 
as your LAN PCs. See Chapter 4 for instructions. 
  An IP-enabled WAN interface. The interface type can be 
PPP or EoA. An IPoA interface can also be used, but they 
are rarely used in customer settings. See Chapter 5 for 
instructions. 
o
  If an EoA interfaces is created, an IP address should 
be assigned to it. Or, the interface should be 
configured to receive an IP address through DHCP. 
o
  For PPP interfaces, IP information is assigned when 
the link is negotiated. 
o
  For either type of WAN interface, the Default Gateway 
check box is normally selected. 
  Each PC’s IP properties specify the ADSL/Ethernet router's 
LAN interface as its gateway IP address. The PCs may 
also be configured to obtain IP information automatically 
from a DHCP server. 
With this configuration, all IP packets originating from your LAN and 
destined for the Internet will be routed to the PCs’ default gateway 
(the LAN interface), then to the Hurricane 9200/S’s default gateway 
(the WAN interface), and then to the WAN interface’s gateway (the 
ISP’s access server). 
In the System View page in the Home tab, the Mode field will reflect 
Routing. With no bridging services enabled, non-IP packets will be 
ignored.