Справочник Пользователя для Pelco Stereo Receiver FR8308

 

14

C1647M-A (6/06)

 

The FT8308 transmitter/FR8308 receiver can be mounted to a wall in the following ways:

 

•

 

Using the supplied wall clip for attachment of a single module to a wall. For installation 
instructions, refer to the 

 

 section 

below.

 

•

 

Using the optional WM5002 wall mount kits, which are designed for mounting of double-
width fiber optic modules. The WM5002-3U base kit allows mounting of a single module to a 
wall. The WM5002-3UEXP expansion kit allows mounting of an additional module. It is 
recommended that a maximum of one expansion kit be used with the base kit, allowing a 
maximum of two double-width modules to be attached to a wall.

 

The WM5002 wall mount kits can be used with the WM5001 wall mount kits, which 

are designed for mounting of single-width fiber optic modules. If mounting a mix of single-width 
and double-width modules is desired, it is recommended that a maximum of two single-width 
modules and one double-width module be mounted in combination with one another.

For mounting instructions using the wall mount kits, refer to the WM5000 Series W all Mount 
Kit Installation manual.

 

Before mounting the FT8308 transmitter/FR8308 receiver to a wall, ensure that there is 

adequate space at both ends for viewing the front-panel LEDs and for making the various rear-panel 
cable connections.

To attach the FT8308 transmitter/FR8308 receiver to a wall using the supplied wall clip, refer to 
Figure 6 and do the following:

1. Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using 

two screws (not provided).

2. Slide the module into the clip until the two holes on the bottom of the module align with the 

two holes on the lower flange of the clip.

3. Attach the module to the clip using the two Phillips pan head screws provided for the clip.