Справочник Пользователя для Pelco NET104A Series C2900M-B

16

C2900M-B (1/03)

Key:
1

= Cameras or other video sources with composite PAL or NTSC output

2

= Video monitor with composite PAL or NTSC input

3

= NET104A transmitter

4

= NET101R/RA Receiver

Figure 3.  Connecting Cameras Or Monitor

• To connect the cameras, plug one end of a standard coaxial cable into a BNC connector (start

with video 1) on the rear of the NET104A and the other end into the camera. You can use any
video source with a composite PAL or NTSC output.

• Set the DIP switches on the NET104A to position 75 OHM ON (down) to terminate the inputs

when the video signal is not connected to additional video equipment through a T-connection.

• To connect a monitor to the NET101R/R-A receiver, plug one end of a standard coaxial cable

into the BNC connector on the NET101R/R-A and the other end into the monitor. You can use
any PAL or NTSC video monitor with a composite PAL or NTSC input.

For more information about video sources and monitors, see the 

Hardware Installation section.

TRANSMITTER

RECEIVER

�

�

�

�

Follow the next six steps for the fastest way to get your product operating.