Справочник Пользователя для Pelco Matrix Switcher/Controller CM6800E-48X8
C1528M-F (6/05)
95
1
2
3
4
5
6
7
8
16
8
7
6
32
31
4
3
2
120/230~
50/60 HZ
50/60 HZ
25 WATTS
1 2 3 4 5 6 7 8
CONTROL
A T
+
T
-
R
+
R
-
T
+
T
-
R
+
R
-
B
1
2
F
3
1
010101
DIP SWITCH
COVER PLATE
COVER PLATE
Figure 64. Dip Switch Cover Plate
Figure 65. CM6800E DIP Switch 7
SOFTWARE RESET
Pelco strongly recommends uploading system settings to the CM6800E-
MGR before the software reset – this will allow you to restore system
settings after the software reset.
MGR before the software reset – this will allow you to restore system
settings after the software reset.
CAUTION: Resetting the software restores the system to
default settings.
default settings.
1.
Remove the two screws and the DIP switch cover plate from the rear
of the switcher.
of the switcher.
2.
Move DIP switch 7 to the ON position (to “0”).
3.
Cycle power.
The switcher will go through a software clear cycle and reset to
factory defaults.
factory defaults.
4.
Move DIP switch 7 to the OFF position.
Failure to move DIP switch 7 to the OFF position could result in loss
of system settings during a power outage.
of system settings during a power outage.
5.
Re-initialize keyboards by entering the monitor number and then
pressing the MON key.
pressing the MON key.
6.
Download your previous system settings (revise settings as
necessary) from the CM6800-MGR.
necessary) from the CM6800-MGR.
SWITCH 7:
ON = SOFTWARE RESET
OFF = NORMAL SYSTEM
ON = SOFTWARE RESET
OFF = NORMAL SYSTEM
OPERATION