Справочник Пользователя для Pelco MX 4000 Genex Series Simplex Multiplexer C1927M

Pelco Manual C1927M (5/99)

21

NO CHANGE - This is a pass-through selection in case you unintentionally hit the +/-
button. This is not an undo button.

Refer to the 

Alarms

 section for an explanation of normally closed and normally open

operation.

Sets the sequence dwell rate for all cameras. To set individual dwell rates for cameras,
refer to the 

Sequence Setup

 section.

ENABLED/DISABLED - Turns activity detection on or off for all video inputs. To set
individual inputs, refer to the 

Camera Setup 

section.

NO CHANGE - This is a pass-through selection in case you unintentionally hit the +/-
button. This is not an undo button.

5.

When you have completed all the changes you want to make, go to EXIT or AD-
VANCED SETUP.

6.

Press the +/- button to exit the programming mode or to go to the advanced system
setup menu.

When HELP is highlighted, you may press the +/- button to display a help screen that will
tell you which buttons to press to configure specific options.

To program the advanced main system parameters:

1.

Press the VIEW button for approximately three seconds. The basic System Setup
menu appears.

2.

The currently selected menu item blinks. Use the arrow buttons to highlight AD-
VANCED SETUP.

3.

Press the +/- button.

4.

The Advanced System Setup menu appears.

5.

Use the arrow buttons to move between items on the screen.

6.

When the menu item you desire is highlighted (blinking), press the +/- button to cycle
through the options.

Figure 12.  Advanced System Setup Menu

ALL COLOR
COLOR & B/W
RESERVED

DATE FORMAT 

MM-DD-YY

PASSWORD DISABLED
FRONT PANEL CONTROL  ENABLED

MAIN MONITOR DISPLAY
RESPONDS TO 

NONE

SPOT MONITOR DISPLAY  SEQUENCE
RESPONDS TO 

ALARMS

CAMERA TYPES 

ALL COLOR

UNIT ID 

001

COMM. TYPE 

MASTER (KBD-T/D)

RELAY OUTPUT 

ALARM

MASTER (KBD-T/D)
SLAVE

001–240

BLANK
SEQUENCE
TRACK MAIN