Справочник Пользователя для Transition Networks BFFG1XXX-1XX

Transition Networks 

 

Section lV:  FBRM/BFFG Initial Device Setup 

 

Use the ‘set’ commands to set the IP configuration through the USB port. Configure 
the Device with a network IP address, subnet mask, and default gateway. Set the IP 
address via USB CLI (Command Line Interface), or via DHCP (Dynamic Host 
Configuration Protocol), which is disabled by default. 

  

The factory default IP configuration shipped with the Device is as follows: 
•  IP address: 

192.168.1.1 

•  Subnet Mask:  255.255.255.0 
•  Gateway: 192.168.1.2 

 

Note:   Type “

help set <command>” to display the format used to set the commands. 

 

To set the IP via the USB CLI, do the following: 

1.    At the 

console> prompt type set ip=nnn.nnn.nnn.nnn 

2.    Press the ENTER key to set the IP address. 
3.    At the 

console> prompt type set netmask=nnn.nnn.nnn.nnn 

4.    Press the ENTER key to set the netmask. 
5.    At the

 console> prompt type set gateway=nnn.nnn.nnn.nnn 

6.    At the

 console> prompt type save  

7.    Press the ENTER key to save the new IP configuration. 

 
 

24-Hour Technical Support:   1-800-260-1312   International: 00-1-952-941-7600 

35