Справочник Пользователя для Transition Networks BFFG1XXX-1XX
Transition Networks
Section lV: FBRM/BFFG Initial Device Setup
Initial Device setup via USB CLI
IP
configuration
configuration
Use the ‘set’ commands to set the IP configuration through the USB port. Configure
the Device with a network IP address, subnet mask, and default gateway. Set the IP
address via USB CLI (Command Line Interface), or via DHCP (Dynamic Host
Configuration Protocol), which is disabled by default.
the Device with a network IP address, subnet mask, and default gateway. Set the IP
address via USB CLI (Command Line Interface), or via DHCP (Dynamic Host
Configuration Protocol), which is disabled by default.
Factory default
IP config
IP config
The factory default IP configuration shipped with the Device is as follows:
• IP address:
• IP address:
192.168.1.1
• Subnet Mask: 255.255.255.0
• Gateway: 192.168.1.2
• Gateway: 192.168.1.2
Note: Type “
help set <command>” to display the format used to set the commands.
Set IP config
via USB CLI
via USB CLI
To set the IP via the USB CLI, do the following:
Step
Action
1. At the
console> prompt type set ip=nnn.nnn.nnn.nnn
2. Press the ENTER key to set the IP address.
3. At the
3. At the
console> prompt type set netmask=nnn.nnn.nnn.nnn
4. Press the ENTER key to set the netmask.
5. At the
5. At the
console> prompt type set gateway=nnn.nnn.nnn.nnn
6. At the
console> prompt type save
7. Press the ENTER key to save the new IP configuration.
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
35