Справочник Пользователя для TP-LINK TL-SG2008

 

35 

If the LAG is needed, you are suggested to configure the LAG function here before configuring the 

other functions for the member ports. 

1.  Calculate the bandwidth for a LAG: If a LAG consists of the four ports in the speed of 

1000Mbps Full Duplex, the whole bandwidth of the LAG is up to 8000Mbps (2000Mbps * 4) 
because the bandwidth of each member port is 2000Mbps counting the up-linked speed of 
1000Mbps and the down-linked speed of 1000Mbps. 

2.  The traffic load of the LAG will be balanced among the ports according to the Aggregate 

Arithmetic. If the connections of one or several ports are broken, the traffic of these ports will 
be transmitted on the normal ports, so as to guarantee the connection reliability.   

The LAG function is implemented on the LAG Table, Static LAG and LACP Config configuration 

pages. 

On this page, you can view the information of the current LAG of the switch. 

Choose the menu Switching→LAG→LAG Table to load the following page. 

 

Figure 5-7 LAG Table 

The following entries are displayed on this screen: 

¾

Select the applied scope of Aggregate Arithmetic, which 
results in choosing a port to transfer the packets. 
•   SRC MAC + DST MAC: When this option is selected, 
the Aggregate Arithmetic will apply to the source and
destination MAC addresses of the packets.   
•  SRC IP + DST IP: When this option is selected, the 
Aggregate Arithmetic will apply to the source and destination 
IP addresses of the packets. 

¾

Select the desired LAG. It is multi-optional.