Справочник Пользователя для Packard Bell EXPRESS ST8000
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
top and right edge. Left side of page extends to 9.25 inches.
Single-Bus Cabinet Configuration
Ch 0
TOP
Ch 1
Ch 1
Ch 0
Ch 1
Host Computer
I/O Interface
Card
Card
Ultra Wide SCSI Data Cable (1 meter)
I/O Interface
Card
Card
Ultra SCSI
Controller
Controller
Note: SCSI termination in the DEU is automatic and
requires no user configuration. Refer to “Cabling
Configuration” described earlier for information on
systems using DEC Fault bus protocol.
requires no user configuration. Refer to “Cabling
Configuration” described earlier for information on
systems using DEC Fault bus protocol.
3
Turn on the power to the DEU. After the power-on
self-test has completed, Status and Channel Mode
LEDs will be solid green.
self-test has completed, Status and Channel Mode
LEDs will be solid green.
4
Access the Options menu on the Operator Control
Panel and choose the SAFTE CHAIN ID selection.
Choose the “None” selection, refer to “SAFTE CHAIN
ID” described later in this guide.
Panel and choose the SAFTE CHAIN ID selection.
Choose the “None” selection, refer to “SAFTE CHAIN
ID” described later in this guide.
5
After setting the cabinet identifications you must
power cycle the subsystem. Observe normal power
cycling precautions by waiting a minimum of five (5)
seconds before adding power again.
power cycle the subsystem. Observe normal power
cycling precautions by waiting a minimum of five (5)
seconds before adding power again.
This will reset the SCSI IDs to a default setting that
prevents a SCSI ID conflict under normal conditions.
prevents a SCSI ID conflict under normal conditions.
6
Power up your computer system and run the
configuration program.
configuration program.
This completes the hardware installation.
Note: For additional configuration options using Ultra
Wide SCSI, refer to Appendix D.
Wide SCSI, refer to Appendix D.