Справочник Пользователя для Packard Bell EXPRESS ST8000
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
top and right edge. Left side of page extends to 9.25 inches.
5
Grasp the handle of the subject power supply and
pull the supply out of the DEU cabinet.
pull the supply out of the DEU cabinet.
6
Remove the new power supply from the shipping
carton and inspect the shipment. Save the packaging
material.
carton and inspect the shipment. Save the packaging
material.
7
Slide the new power supply into the cabinet until it
reaches its locked position. Orient the supply in the
same manner as the removed power supply. (Air
slots in the PSU case face toward the center of the
cabinet.)
reaches its locked position. Orient the supply in the
same manner as the removed power supply. (Air
slots in the PSU case face toward the center of the
cabinet.)
The new power supply’s LED should illuminate.
8
Close the rear door panel. The door has a latch
mechanism to hold the door in the open position.
Squeeze the latch to release the door allowing it to
be closed.
mechanism to hold the door in the open position.
Squeeze the latch to release the door allowing it to
be closed.
If you are replacing the #3 power supply, re-install
the PSU Cover Plate and then re-secure the power
cord retainer.
the PSU Cover Plate and then re-secure the power
cord retainer.