Справочник Пользователя для Packard Bell EXPRESS ST8000

PRINTER NOTE: Page size 9” x 9.25”.  Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.

This chapter provides solutions for some of the
problems you may encounter while using the DEU.

Fails to power on.

Power cord not connected properly.

Power not available at the outlet.

Power switch not in the proper
position.

Faulty fuse.

Faulty power cord.

Verify that the power cord is properly
connected to the power module.

If the DEU is plugged into a three-hole
grounded outlet, verify if power to the
outlet has been interrupted. This can be
accomplished by testing the outlet with a
known working appliance, like a lamp.

Be sure that the power switch is in the
“ON” position, labeled “I”.

Replace fuse, see 

Replacing a Fuse

described earlier in this guide.

Replace power cord.

If the DEU is not responding,
contact

 

your service provider.

Operator Control Panel
display indicates
“Hardware Error.”

Possible component failure.

From the Operator Control Panel,
“Hardware Menu” from the Main Menu
and select “Component Status.” Scroll
down through the list to locate the failed
component. Follow the procedures in
the 

Maintenance

 chapter to replace the

failed component.

LED and audible alarms
indicate the system
failed the diagnostic
test.

Power-on self-test failed.

From the Operator Control Panel,
“Hardware Menu” from the Main Menu
and select “POST Results.” Scroll down
through the list to locate the failed
component, see 

Power-On Self

Diagnostics

 described earlier in this

guide.

Operator Control Panel
display indicates
cabinet temperature
threshold has been

Cooling fan failure.

From the Operator Control Panel,
“Hardware Menu” from the Main Menu
and select “Component Status.” Scroll
down through the list to locate the failed