Справочник Пользователя для Packard Bell REFDOCS02420200

2 

This document contains step-by-step disassembly instructions for the Stella (iXtreme) chassis. The 
instructions are illustrated where necessary with images of the part that is being removed or 
disassembled. Furthermore, the screws that are removed are shown next to the image of the parts 
themselves. 
 
Packard Bell reserves the right to make changes to the Stella (iXtreme) chassis without notice. 
 
 

Only technicians authorized by NEC Computers International BV should attempt to repair this equipment. 
All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. 
Because of the complexity of the individual boards and subassemblies, no one should attempt to make 
repairs at the component level or to make modifications to any printed wiring board. Improper repairs can 
create a safety hazard. Any indication of component replacement or printed wiring board modifications 
may void any warranty or exchange allowances. 
 
 

When disassembling the system unit, follow these general rules: 
 

„

 

Turn off the power and disconnect all cables and peripherals. 

„

 

Do not disassemble the system into parts that are smaller than those specified in the 
instructions. 

„

 

Label all removed connectors; note where the connector goes and in what position it was 
installed. 

 
 

Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are 
returned to their proper positions. Check that no tools or any loose parts have been left inside the 
chassis. Check that everything is properly installed and tightened. 
 
 

All disassembly procedures can be performed using the following tools: 
 

„

 

Philips (#2 bit) screwdriver