Справочник Пользователя для Toshiba VF010H05

The soft starter comes with an RTD card that provides 12 

programmable RTDs which are individually programmable 

for type. The available types are 100 ohm platinum, 100 ohm 

nickel, 120 ohm nickel and 10 ohm copper. Each RTD can 

be identified with a description name of up to 15 characters 

(including spacing). Also, each individual RTD has it own alarm 

and trip level.

SP9.1 Use NEMA Temp for RTD Value: When this setpoint 

is enabled, the soft starter will use the NEMA design 

insulation class to limit the maximum allowed range 

of the alarm and trip level. The maximum allowed 

temperature range is 240° C or (464°F).

SP9.2 # Of RTD’S Used for Stator: Up to six RTDs can be 

assigned to monitor the stator of the motor.

SP9.3 RTD Voting: When this is enabled, the soft starter will not 

post a trip until 2 RTD’s have exceeded the trip level. 

This prevents nuisance RTD tripping.

SP9.4 All 12 RTDs are configured in the following manner. The 

first column is the RTD type, the second column is the 

RTD description, the third column is the alarm level, 

and the fourth column is the trip level.

 

  The first six RTDs have been pre-programmed with 

a description name for the STATOR, with two RTDs 

per phase. RTDs #1 & #2 have been named STATOR 

PHASE A1 and A2 respectively. RTDs #3 & 4 are 

named STATOR PHASE B1 and B2, RTDs #5 & 6 

are named STATOR PHASE C1 and C2. If other 

description names are required, press the right arrow 

button from the RTD Type screen to go the RTD 

description screen. If no alarm or trip level is required 

these setpoints can be turned off.