Справочник Пользователя для Telit Wireless Solutions Easy GPRS

 
 
 
 

 
 

80000ST10028 Rev. 0 - 02/01/07  

  

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved 

 

page 23 of 35 

 

2.2.2 Setting the FTP Transfer Type 

 
With the command AT#FTPTYPE[=<type>]  is possible to configure the file transfer type. The 
command must be provided during an FTP connection. 
 
Parameter: 
<type> - file transfer type: 
  0 - binary 
  1 - ASCII 
 
NOTE: The command causes an ERROR result code to be returned if no FTP connection has been 
opened yet. 
 
NOTE: If the parameter is omitted then the behaviour of Set command is the same of Read command. 
 

2.2.3 FTP File transfer to the server 

 
With the command AT#FTPPUT=<filename> , to issued during an FTP connection, is possible to 
open a data connection and starts sending <filename> file to the FTP server.  
 
If the data connection succeeds, a CONNECT indication is sent, otherwise a NO CARRIER indication 
is sent. 
 
Parameter: 
<filename> - string type, name under which you choose to save the file on the server (must have the 
right extension: es. if the file you’re sending is .txt then the <filename> can be test.txt)  
 
NOTE: use the escape sequence +++ to close the data connection. 

 
NOTE: The command causes an ERROR result code to be returned if no FTP connection has been 
opened yet. 
 
 
 

Example of an FTP file transfer to the server: 
 
Define PDP contest: 
AT+CGDCONT=1,”IP”, "internet.wind.biz"<cr> 
OK 
 
GPRS Context Activation, as response gives IP of the module: 
AT#GPRS=1<cr> 
+IP: 193.199.234.255 
OK