Справочник Пользователя для Oregon Scientific RA900
11
EN
CYCLING PROFILE
SETUP
Except wheel size setting, you could set up all for cycling profile following by the
SETUP section in RUNNING PROFILE.
NOTE
Make sure bike pod sensor is paired with the watch before cycling.
The setup mainly includes the following parts:
•
Lap
•
Interval
•
Rest
•
HR Zone
•
Wheel size
Wheel size setup
1. In
CYCLING mode, press top (1) button to enter, and
the paired sensor icons display on the screen. Press
bottom (
3) button to skip if the sensor is added.
2. Press middle (
2) button to enter setup mode.
3. Toggle middle (
2) button until adjust Wheel size displays.
4. Press top (
1) button to enter.
5. Press top (
1) button again to increase the value or press bottom (3) button to decrease the value.
6. Press middle (
2) button to confirm selection.
USEFUL REFERENCE
About Bike Wheel Size
Match the ETRTO or wheel size diameter printed on the wheel with the wheel size setting at the right hand column of the table below. Input the relevant wheel size setting
number after bike pod is paired.
Match the ETRTO or wheel size diameter printed on the wheel with the wheel size setting at the right hand column of the table below. Input the relevant wheel size setting
number after bike pod is paired.
ETRTO
Wheel size diameter (inches)
Wheel size setting (mm)
25-559
26 x 1.0
1884
23-571
650 x 23C
1909
35-559
26 x 1.50
1947
37-622
700 x 35C
1958
47-559
26 x 1.95
2022
20-622
700 x 20C
2051
52-559
26 x 2.0
2054
23-622
700 x 23C
2070
25-622
700 x 25C
2080
28-622
700 x 28
2101
32-622
700 x 32C
2126
42-622
700 x 40C
2189
47-622
700 x 47C
2220
NOTE
Wheel sizes on the above table are for reference only as wheel size depends on the wheel type and air pressure.
VIEW EXERCISE RECORD DURING CYCLING
You could start cycling by following the steps below, and if you set up the
Interval, the distance or timer will count down.
NOTE
Make sure the watch has enough memory, otherwise
no memory displays when you press button after CYCLING mode.
To view cycling records:
1. In
CYCLING mode, press top (1) button to enter, and the paired sensor icons display on the screen. Press bottom (3) button to skip the searching mode if the sensor is added.