Информационное Руководство для Q-See QSTD5304

NOTE!  You  will  only  need  to  proceed  with  this  section  if  you  detected  a 
second router in Section 2.

NOTE!  If you do not have a DMZ setting in the router, check to see if there 
is a 

Bridge setting. If so, then use the Bridge setting instead of DMZ.

STEP 1. Login into Router 1 by putting 

the IP of Router 1 into the Internet 
Explorer browser, as in the example 
shown in 

Picture 23

 where the IP 

address of Router 1 is 192.168.0.1

STEP 2. Find the status page on the 

router settings that shows the WAN/
Internet IP address and  write it down 
this WAN IP address.

STEP 3. Log into the Router 2 by putting 

the IP of Router 2 into the Internet 
Explorer browser, as in example 
shown in 

Picture 23

 where the IP 

address of Router 2 is  192.168.1.1

STEP 4. Find the DMZ page in the router 

settings.

STEP 5. Enter the WAN IP for Router 1 

into the 

DMZ page and enable DMZ.

STEP 6. Save your changes.

You have forwarded the ports on the router to which the DVR is connected, to the IP address 
of the DVR, and set the primary router to pass the connection to this router.