Справочник Пользователя для KYOCERA KR1
Installation Instructions
7
4
Installation Instructions
Connect the Kyocera KR1 Wireless Router to Your Network
Note:
Ensure that power to your Kyocera KR1 Mobile Router is not connected before performing the
installation steps below
.
32-bit PCMCIA (EVDO) Card or 1xEV-DO Mobile Phone Connection
Note:
To preserve the life of your phone’s battery, it is recommended that you use your phone’s charging
cradle when connected to the Kyocera KR1 Mobile Router.
cradle when connected to the Kyocera KR1 Mobile Router.
1. Attach the antenna.
a.
Remove the antenna from its plastic wrapper.
b. Screw the antenna in a clockwise direction to the back panel of the unit.
c.
Once secured, position the antenna upward at its connecting joint. This will ensure optimal reception.
2. Connect a compatible 32-bit PCMCIA (EVDO) card with service, or 1xEV-DO mobile phone with service, to
the Kyocera KR1 Mobile Router in one of the following ways:
a.
Insert your wireless 32-bit PCMCIA (EVDO) card into the WAN (EVDO) 32-bit PCMCIA Card Slot, or
b. Connect your wireless 1xEV-DO mobile phone to the “Phone In” jack, with your USB phone cable.
Note:
The Kyocera KR1 Mobile Router is designed to work with EVDO-capable handsets that can be used as
a modem (support tethered data). Please refer to your service provider for detailed feature
information. Support is also available at
a modem (support tethered data). Please refer to your service provider for detailed feature
information. Support is also available at
http://www.kyocera-wireless.com/support
.
3. Insert the Ethernet patch cable into LAN Port 1 on the back panel of the Kyocera KR1 Mobile Router, and an
available Ethernet port on the network adapter in the computer you will use to configure the unit.
Note:
The Kyocera KR1 Mobile Router LAN Ports are “Auto-MDI/MDIX.” This provides either patch or
crossover Ethernet cable LAN Port access.
crossover Ethernet cable LAN Port access.
4. Connect the power adapter to the receptor on the back panel of your Kyocera KR1 Mobile Router.
Then plug the other end of the power adapter into a wall outlet or power strip.
a.
The Power LED will turn ON to indicate power has been applied.
b. Other LEDs will flash ON and OFF as the Kyocera KR1 Mobile Router performs initialization and Internet
connection processes. This will take a few minutes.
c.
When complete, the following LEDs will illuminate green: Power, Status, WAN, WLAN, and LAN Port 1
(or your specific LAN Port connection).
(or your specific LAN Port connection).
Note: For 1xEV-DO Phone Users
if you have connected a 1xEV-DO mobile phone to your Kyocera KR1
Mobile Router, the Phone LED will also illuminate green.
Establish WiFi Connection
If you selected either
WEP
or
WPA-PSK
encryption, ensure these settings match your WiFi adapter settings.
WiFi and encryption settings must match for access to the Kyocera KR1 Mobile Router Configuration Menu, and the
Internet. Please refer to your WiFi adapter documentation for additional information.
Internet. Please refer to your WiFi adapter documentation for additional information.