Инструкции Пользователя для Korg Toneworks AX1500G

If you find the expression pedal difficult to use,
perform this procedure so that the pedal will function
optimally. For example if the effect does not reach
maximum when the pedal is advanced all the way
forward, or does not reach minimum when the pedal is
returned all the way back, use the following procedure
to make the appropriate adjustments.

When making adjustments, use your hand to move the
pedal. Accurate calibration may not be possible if you use
your foot to operate the pedal.

1. Turn on the power while simultaneously holding

down the EXIT switch and the PEDAL effect block
select switch.The name display will show “

”

for approximately one second, and will then
indicate “

.”

Turn on the power while simultaneously holding down

2. Slowly return the pedal to the full back position.

When it stops, release your hand and press the
WRITE 

switch. The name display will change from

“

” to “

.”

If you decide to halt the adjustment procedure, press the
EXIT switch. The power-on display will appear, and you
will enter Play mode.

3. Slowly advance the pedal. When it stops, release

your hand and press the WRITE switch.

2. Press slowly

3. Press slowly

The LCD display will indicate “

” for approxi-

mately one second. Then the power-on display will
appear, and you will enter Play mode.
After the adjustment procedure has been completed,
verify the operation of the pedal.
Select an effect that will make it easy to verify the
adjustment. For example, set the pedal effect block to
the VOLUME effect, set the value to 0, and check the
MIN level when the pedal is returned all the way back.

If you make a mistake during the calibration procedure,
the LCD will indicate “ERROR,” and you will return to the
screen before the adjustment (the “MIN” display). If the
“ERROR” display appears for repeated attempts, a
malfunction may have occurred. In this case, please
contact your dealer.

1. Turn on the power while simultaneously holding

down the EXIT switch and the bank switch. The
name display will indicate “

”

If you press the EXIT switch, the reload operation will not
occur; the power-on display will appear, and you will enter
Play mode.

2. Press the WRITE switch. The name display will

change to “

,” and the reload operation

will begin. When the reload operation is completed,
the display will indicate “

” for approxi-

mately one second. Then the power-on display will
appear, and you will enter Play mode.

Never turn off the power during the reload operation.

WARNING: When you perform the reload operation, all
user programs will be rewritten. Master level, metronome,
and input level settings will also be initialized.