Листовка для Knoll Systems Stereo Receiver IR320

Скачать
Страница из 2
IR320 Infrared Receiver Specifications: 
 
Specifications 
Infrared carrier frequency:   25-65 kHz 
Indoor reception range:  
100 feet (30 meters) max. 
Nominal reception angle:   50 degrees off axis 
Maximum wire length:  
1000’ (300m) or even more with 
larger gauge wire 
Wire requirements:    
3 conductors, minimum 24-gauge 
      
 
 
 
to 200’; 22-gauge up to 500’;  
20-gauge to 1000’ 
Power requirements:  
12VDC, 40mA 
Dimensions:    
 
15/19” x 3/8” x 1/2" h  
(24 mm x 10 mm x 13mm h) 
 
Requires 12VDC power supply, emitter(s) and a 
connection block. 
 
 
 
Warranty 
 
Knoll Systems warrants its products (with certain exceptions) sold in the USA 
and Canada by authorized Knoll dealers to be free of defects in materials and 
workmanship. This warranty extends for three full years from the date of 
purchase by the original consumer. Any products returned to Knoll Systems and 
found to be defective by Knoll Systems within the warranty period will be 
repaired or replaced at Knoll Systems option, at no charge. Knoll Systems will 
not be responsible for the actual cost of installation or removal of the product, 
nor for any incidental or consequential damages. Some states do not allow the 
exclusion or limitation of incidental or consequential damages, so the above 
limitation may not apply to you.  This warranty gives you specific legal rights.  
You may have additional legal rights that vary from state-to-state. 
 
 
 
 
 
 
 
 
Knoll Systems www.knollsystems.com   
145 Tyee Drive Point Roberts, WA 98281 
14-7163 Vantage Way, Delta BC V4G 1N1 
Telephone: (604) 940-1689, Fax (855) 734-3363 
www.knollsystems.com 
Made in Canada   Knoll Systems All Rights Reserved 
IR320
 
 
Micro Infrared Receiver  
Installation Instructions 
v1.0 
 
Warning
: To be installed and/or used in accordance with 
appropriate electrical codes and regulations.  
 
Introduction:
 Thank you for your purchase of a Knoll IR320 
infrared receiver. This receiver features the ability to pick up a 
remote control infrared signal and relay it on wires to the inside 
of a cupboard or to another location up to 1000’ (or more).  
 
 
                                                
Actual size 
Features: 
  
 
Very small design. 
 
More forgiving than previous 
designs and can work short 
distances in direct sunlight
 
Will relay almost all remote 
control types. 
 
Requires very little power. Suggest using Knoll PS1205 
     for up to ten IR320’s.  
 
Up to ten Knoll infrared receivers can be connected in a 
single system. 
 
Available in black, white and silver colors. 
 
Connects with a three wire connector or 3.5mm plug. 
 
 
 
Installation Tips 
 
1. Follow all local electrical & building code requirements. 
 
2. The IR320 is usually mounted to the wall or cabinet using the 
included double sided tape. For easy installation and to ensure 
reliability, it is suggested to use a Knoll PS1205 power supply, 
Knoll single or dual emitters and a Knoll connection block or 
hub.