Справочник Пользователя для MURO METAL PRO CH7260

Ver: 10/14/2004                                                        3 

Maintenance and Inspection of CH7260 
 

For best results keep your CH7260 Metal Pro Clean and Free of dirt and debris for 

smooth operation.  Inspect and Blow out or vacuum it after use.  Built up dust and dirt may 
cause tool wear.  To clean the tool, use a damp cloth or soap and water damped cloth, do not 
use thinners or gasoline or other solvents that would damage the unit, or fully immerse it in 
water, which may cause rusting.  Bits are consumable and must be replaced if worn, bits are 
specially designed for the Muro auto feed system.  

 

 
 

outwards per the diagram on the side of the screwdriver.  The strips must be inserted as 
shown to work properly i.e. only one way works, if inserted backwards, they will jam.  
Generally, the correct end of the strip will be longer.  Check that the free end of the strip fits 
into the strip guide, Latch (hook) the first screw with the feed latch  (Photo 2).  

 The strip guide supports the screw strip, assisting in keeping the screws in the correct 

position for pick up by the bit, particularly for the last screws to be driven.  The strip spring 
acts to keep tension and a ratchet on the screw strip, also keeping the screws in the correct 
position. 
 

 
 
 
 
The strips must be 
inserted as shown to 
work properly i.e. 
only one way works, 
if inserted backwards, 
they will jam.  Latch 
in the first screw.  

1