Справочник Пользователя для Multi-link Multi-Link Acp-300 ACP-300

Flag 6 (Bit 2) Busy Signal 1 (on)  

Determines if a device trying to access the line when the line is already in use will hear a busy 
tone or dead air. 
 

Flag 7 (Bit 1) Enable Multi-Port Polling 0 (off) 

Allows transfer to another device when 

communication with the first device addressed is complete. 
 

Flag 8 (Bit 0) Night Watch Mode to Device 3 0 (off)  

Determines if night watch transfers are transferred to device 3.  
(Default night watch port is device 2) 

 
The operation modes (Flags) can be programmed to meet the specifications that 
your system requires to function optimally. 
 
REGISTER 02 - Cadence On Time 
This register can range from 1 to 6 in one-half seconds and controls the amount 
of "ring" time in the ring cadence, Factory preset to 4 (2 seconds). 
 
REGISTER 03- Cadence Off Time 
This register can range from 1 to 15 in one-half seconds and controls the length 
of silent time between each ring, Factory preset to 8 (4 seconds). 
 
REGISTER 04 - Maximum Number of Rings to a Device 
This register can range from 1 to 99 and controls the amount of rings sent to a 
device port. Factory preset to 8 rings. 
 
REGISTER 05 - Night Watch Mode Trip Rings 
This register contains the number of rings that are required to trip the Night 
Watch Mode function, After an incoming call has been screened, the number of 
rings to the phone port are counted, and if the phone is not answered in "X" 
rings, this call and all future calls will be diverted to the Device port 2. This 
register can range from 1 to 15. Factory preset is 5 rings. 
 
REGISTER 06 - Night Watch Mode Rings 
This Register contains the number of rings to the phone device port after Night 
Watch Mode (Register 05) has been activated. This number is usually less than 
register 05 but can range from 1 to 15. Factory preset is 2 rings. 
 
REGISTER 07 – Emergency Barge In 
This register contains the mask that determines if Devices 1, 2, 3, and 4 can 
barge in and gain access to the telephone line by going off-hook during a call. 
The four mask bits can be set to any combination of values, allowing all, some, or 
none of Devices 1 through 4 access to the line during an emergency or to just 
have priority.