Справочник Пользователя для Meridian America 555-8421-211

34

Meridian Digital Telephone IP Adapter Installation and Administration Guide

Planning for installation

 Standard 1.1

Refer to the Remote Office Network Engineering Guidelines
(NTP 555-8421-103) for detailed information on planning and preparing your 
network for the addition of IP Adapter units. The Meridian Digital Telephone IP 
Adapter unit communicates with the host PBX using the IP network. To use the 
Meridian Digital Telephone IP Adapter unit in these networks, you must 
consider the issues described in this section.

To place and receive calls over the IP network, you must:

!

physically connect the Meridian Digital Telephone IP Adapter unit to the IP 
network

!

assign a unique IP address and a subnet mask to the Meridian Digital 
Telephone IP Adapter unit, unless using Dynamic Host Configuration 
Protocol (DHCP)

Note: Similarly, you must assign a subnet mask, gateway, and unique IP 
address to the RLC on the host PBX.

!

have the ability to send and receive traffic to and from the RLC on the host 
PBX

If you use DHCP at the remote location, determine the Remote Office Unit's IP 
address by checking the Network statistics for the RLC through Configuration 
Manager. Log onto Configuration Manager, choose the RLC as the Device Type, 
and then access Alarms/Stats/Logs 

➝

 Network Statistics. Enter the Unit ID of 

the Remote Office unit that you want to review the statistics for. The DHCP 
assigned IP address displays at the top of the window.

Note: If you are using a Network Address Translation (NAT) router at the 
remote location, the IP address provided is a NAT address. To access the Remote 
Office unit using Telnet, ensure that the NAT router allows Telnet access to TCP 
port 23, and for upgrades, TCP port 69.