Справочник Пользователя для Marantz STRIKER S160

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

PTional

loWer

nsTallaTion

A blower, part# 71000, can be installed on the stove

to improve hot air distribution throughout the room.

To install the blower:

1. Remove all the contents from the blower box. Included

with the blower should be a blower speed control.

2. Remove the screws in the round knock-out plate on

the back of the stove. Bend the knock-out plate back

and forth until it can be removed.

3. Mount the blower as shown below. Make sure the cord

is at the bottom when mounted and that it does not

touch the stove anywhere. Remove the four screws

from the back of the stove. Use one of the four screws

with a washer on it and attach the blower through

one of the four mounting legs on the blower housing.

Check to make sure that the fan blade does not touch

the large hole in the rear heatshield. (Spin it to check

all directions). Finish attaching the blower with the

other three screws. Tighten the screws moderately

tight but do not over tighten as you may strip the

holes out.

4. Plug in the fan speed control into the nearest outlet,

then plug the blower cord into the speed control. Do

not route the fan power cord under the stove or allow

it to come in contact with any surface of the stove.

Read the section Starting and Maintaining a Fire for

proper fan operating instructions on page 15.

WARNING: In the event that you remove the blower

for any reason, make sure a cover plate available

from Lennox Hearth Products is reinstalled before

using the heater. Excessive rear wall temperatures

will result if the stove is burned without the cover

plate.

PeraTing

inTs

1. Burn only dry, well-seasoned wood for maximum heat

output. In some states it is illegal to burn wet wood

or anything other than clean, dry wood products.

2. Your stove is designed to operate with the door closed!

Operate only with the door shut tightly at all times

except when loading wood.

3. DO NOT hit or move the baffle brick while loading

wood. Occasionally check the baffle. Make sure the

insulating blanket is always flush with the front of the

baffle brick. Loading oversized logs may dislodge the

baffle bricks.

4. CAUTION: THE DRAFT CONTROL MUST BE FULLY

OPEN BEFORE OPENING THE DOOR TO AVOID POS-

SIBLE COMBUSTION FLASH!! (Ignition of hot volatile

gases as the door is opened).

5. Feeding excessive amounts of fuel to the stove should

be avoided. It is important to supply it with sufficient

draft and fuel to maintain a moderately hot fire. If,

during overnight burns, heavy creosote deposits

develop inside your stove and on the door, the draft

is set too low - review your burning habits!