Справочник Пользователя для Maretron Run Indicator Module RIM100
Revision 1.0
Appendix A – NMEA 2000 Interfacing
Page A1
®
®
Appendix A – NMEA 2000
®
Interfacing
RIM100 NMEA 2000
®
Periodic Data Transmitted PGNs
PGN 127501 – Binary Switch Bank Status
The RIM100 uses this PGN to transmit the state of each of the connected switch inputs
Field 1: Indicator Bank Instance – This field identifies the particular switch bank to which this
PGN applies. Please refer to Section 2.5.1 for instructions on how to program the
value of this field.
value of this field.
2: Indicator #1 – This field indicates the state of the switch connected to the V1+ and
V1- inputs of the RIM100. The state will be one of the following values:
• “Off” – No voltage is detected on the monitored load (the load is not running).
• “On” – A voltage is detected on the monitored load (the load is running).
• “Data Not Available” – The indicator is configured as “Disabled”
3: Indicator #2 – This field indicates the state of the switch connected to the V2+ and
V2- inputs of the RIM100.
4: Indicator #3 – This field indicates the state of the switch connected to the V3+ and
V3- inputs of the RIM100.
5: Indicator #4 – This field indicates the state of the switch connected to the V4+ and
V4- inputs of the RIM100.
6: Indicator #5 – This field indicates the state of the switch connected to the V5+ and
V5- inputs of the RIM100.
7: Indicator #6 – This field indicates the state of the switch connected to the V6+ and
V6- inputs of the RIM100.