Справочник Пользователя для Magellan V2 MG-6160
Magellan - X10 Operation User Guide
2
Introduction
X10 is a communication protocol for remote control of electrical devices such as lamps and appliances. Communication is accomplished
through standard household electrical wiring using X10 transmitters and receivers. Magellan can be set as an X10 controller and when
used in conjunction with X10 transmitters, Magellan can be used to automate one’s home. Therefore, you can use Magellan to either
manually or automatically turn ON or OFF lamps, televisions, etc. The Magellan console can support a maximum of eight X10 receivers
or outputs.
through standard household electrical wiring using X10 transmitters and receivers. Magellan can be set as an X10 controller and when
used in conjunction with X10 transmitters, Magellan can be used to automate one’s home. Therefore, you can use Magellan to either
manually or automatically turn ON or OFF lamps, televisions, etc. The Magellan console can support a maximum of eight X10 receivers
or outputs.
Accessing the X10 Setup Menu
The X10 Setup menu is where you configure your X10 House Code and X10 receivers. To access the X10 Setup menu:
1. Press the right [
ACTION
] key (menu) to access the User menu.
2. Press the center [
ACTION
] key (next) seven times to scroll to the Utility Setup menu and then press
the left [
ACTION
] key (ok).
3. Press the center [
ACTION
] key (next) four times to scroll to the X10 Setup menu and then press the
left [
ACTION
] key (ok). Within this menu, you can perform any of the following options:
•
Press the left [
ACTION
] key (ok) to program the present X10 feature.
•
Press the center [
ACTION
] key (next) to scroll through all other X10 programming features.
•
Press the right [
ACTION
] key (exit) to exit the X10 Setup menu.
Enabling/Disabling the X10 Outputs
When programming Magellan’s X10 outputs from within the X10 Setup menu (see “Accessing the X10 Setup Menu” on page 2), you will
be instructing Magellan whether to activate or deactivate one or more X10 outputs. You have the choice of either activating or
deactivating ALL the outputs at once or individual outputs.
be instructing Magellan whether to activate or deactivate one or more X10 outputs. You have the choice of either activating or
deactivating ALL the outputs at once or individual outputs.
Every X10 output comes in two states, ON and OFF and is displayed in separate screens as shown in Figure 1 on page 3. The following
applies when enabling or disabling X10 outputs:
applies when enabling or disabling X10 outputs:
•
Press the left [
ACTION
] key (ok) or press the appropriate key from the Center keypad to enable or disable the displayed X10 state. A
checkmark will appear in the upper right corner of the screen and the appropriate key will be illuminated. See Figure 1 on page 3 for
more information.
more information.
•
Press the center [
ACTION
] key (next) to proceed to the next X10 output state.
•
Press the right [
ACTION
] key (exit) to save your programming and to exit.