Руководство Пользователя для Lorex Technology SG19LD800 Series

Connecting Motion / Alarm Device - Appendix #5

A motion detection or sensor unit can be used to send a signal to the Observation System to 
begin camera viewing on the matching Video Channel (when enabled in the Menu, see page 45):

• Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor 

is activated, the camera on DIN or BNC VIDEO port #4 will become active (if enabled in the 
MENU on the Observation System)

1. Connect the GROUND Cable to the GND port on the Alarm Block on the Observation System

2. Connect the SIGNAL Cable to a numbered port (1-8) 

To start ALARM RECORDING on the System, refer to page 45 for menu configurations.

1-4 / 5-8: Alarm input terminals 
receive a signal from a device (i.e. 
Door or Window Sensor).

NO / NC: Alarm Output Terminals 
send a signal to another device 
when an alarm input is detected.