Справочник Пользователя для Intex Recreation HT30220

(114)  ELECTRIC POOL HEATER  ENGLISH  7.5” X 10.5” PANTONE 295U  

12/18/2006

IMPORTANT: The electrical pool heater must be installed as the last piece
of pool equipment before the saltwater pool or chlorine generator system in
the water return line to the pool

1. Assemble the above-ground-pool (AGP) and its filter pump per 

installation instructions.

2. Remove the electrical pool heater and it’s accessories from the 

packaging.

3. Place the electrical pool heater in line after the filter pump.
4. Connect the hose (1) to the electrical pool heater inlet. (See following 

page)

5. If your above-ground-pool is filled up with water, unscrew the strainer 

grids from the strainer connectors and insert the black hat-like plugs into
the strainer connectors before electrical pool heater installation. Go to 
step 6 directly if your pool is empty.

6. Disconnect the water return (to the pool) hose from the filter pump 

connection, and connect it to the upper electric pool heater connection  
with a hose clamp.

7. Connect the second hose to the lower electric pool heater connection 

and to the lower pump connection. Make sure all the hose clamps (2)
are tight.

8. If applicable, return strainer grids to strainer connectors inside pool after

removing black hat-like plugs that prevented water from flowing out of 
the pool.

9. Connect the electric pool heater to the power outlet. Test RCD as 

shown on following page.

10. Turn pump on. Check water is flowing through the heater. Then turn 

heater on.