Справочник Пользователя для Hypercom ICE 5700 ICE 5700
Wireless POS Terminal Interface
940310-001, rev. A
Hypercom Corporation
4-7
4.
Insert the 24-Volt power cable from the power supply, Hypercom P/N 870003-001, into the terminal
transceiver interface receptacle marked Power. Insert the AC power cable from the power supply
into an appropriate AC receptacle.
transceiver interface receptacle marked Power. Insert the AC power cable from the power supply
into an appropriate AC receptacle.
5.
Insert the male connector of the 12-foot cable from the terminal transceivers into the female
connectors marked Terminal Transceiver 1 or Terminal Transceiver 2 on the terminal transceiver
interface.
connectors marked Terminal Transceiver 1 or Terminal Transceiver 2 on the terminal transceiver
interface.
If the 12-foot cable is not long enough, it may be extended up to 1000 feet by using any four
conductor, one-to-one standard telephone extender cable available at various electronic appliance
retail outlets.
conductor, one-to-one standard telephone extender cable available at various electronic appliance
retail outlets.
You can also have the premises wired for extending the cables. Firms that install telephone cabling
in buildings can perform this task because the wiring is identical to a two-circuit telephone system.
in buildings can perform this task because the wiring is identical to a two-circuit telephone system.
Figure 4-4. Premises wiring diagram
W
ARNING
To avoid damaging the terminal transceiver unit, do not insert the cable connectors from the single unit
adapter or the terminal transceiver into any receptacle designated for use with the premises telephone
system.
adapter or the terminal transceiver into any receptacle designated for use with the premises telephone
system.