Справочник Пользователя для Heath Zenith SL-5679
2
598-1235-01
Lamp
Socket
Photocell
Socket
Ballast
Ignitor
Red
Red
Red
Blac
k
Blac
k
Blue
Blue
White
White
White
Blac
k
White
Blac
k
120V AC
Input
Ballast Assembly Replacement Instructions
1. Remove plastic cover.
2. Remove bulb.
3. Remove five screws attaching reflector to fixture housing.
4. Label wires according to wiring diagram.
5. Remove wire nuts from wires. Retain wire nuts to connect replacement
2. Remove bulb.
3. Remove five screws attaching reflector to fixture housing.
4. Label wires according to wiring diagram.
5. Remove wire nuts from wires. Retain wire nuts to connect replacement
ballast assembly.
6. Remove two screws and lock washers holding ignitor and ballast in
place.
Ballast assembly can be replaced without the
cutting of any wires. Use of a qualified electrician is
recommended.
cutting of any wires. Use of a qualified electrician is
recommended.
Fixture Housing
Ballast
Ignitor
Ignitor Retention Screw
7. Dispose of used ballast assembly.
8. Connect the replacement ballast assembly following steps 1
8. Connect the replacement ballast assembly following steps 1
through 7 in reverse order.
CAUTION: Ballast is held in place by ignitor. Carefully
remove the ignitor and the ballast together to avoid
personal injury in case the ballast slides out of unit.
remove the ignitor and the ballast together to avoid
personal injury in case the ballast slides out of unit.
Lock Washer
Reflector
Reflector Screw (x5)
WARNING: Turn power off at the fuse or circuit
breaker.