Справочник Пользователя для Graco 332574D - RS Gun Cutter Assemblies
Operation
332574D
9
Adjust Anvil to Idler Tension
To adjust the anvil (AC) to idler (AJ) tension, the idler
position can be adjusted. See F
position can be adjusted. See F
1.
Follow Pressure Relief Procedure found within the
RS Gun and Cutter, Operation-Repair manual.
RS Gun and Cutter, Operation-Repair manual.
2.
Engage trigger lock.
3.
Remove cover (627). See page 20.
4.
Loosen idler lockdown screw (617) using 3/16 in.
hex key.
hex key.
5.
Slide idler to desired position.
6.
Tighten idler lockdown screw to lock idler in position.
Adjust Blower Air
NOTE: Blower air adjustment only applies to cutters
shown in F
shown in F
The cutter has blower air to help keep the anvil cool and
to keep the inside of the cover free of debris. The blower
air has been factory set to optimize performance of the
cutter, however it can be adjusted.
to keep the inside of the cover free of debris. The blower
air has been factory set to optimize performance of the
cutter, however it can be adjusted.
Use a 3/32 hex allen key to turn adjusting screw (635)
counter-clockwise to allow more air flow into the inside
of the cover on the cutter assembly. This will affect air
motor performance as less air will go to the air motor
resulting in slower cutter speeds.
counter-clockwise to allow more air flow into the inside
of the cover on the cutter assembly. This will affect air
motor performance as less air will go to the air motor
resulting in slower cutter speeds.
Adjust Cutter Air Pressure
Adjust the incoming air pressure according to the table
below.
below.
635
Number of
Strands
US
Metric
One Strand
50-75 psi
3.4-5 bar, 0.3-0.5 MPa
Two Strands
80-125 psi
5.5-8.6 bar, 0.6-0.9 MPa
Three Strands
80-125 psi
5.5-8.6 bar, 0.6-0.9 MPa