Справочник Пользователя для Gateway Printer 9250C

 

Ping Results

 

Use this item to view the ping test status and results
using the control panel display. You can select the
following items:

Packets Sent

Shows the number of packets (0 - 65535) sent to the
remote host since the most recent test was initiated or
completed.

Packets Received

Shows the number of packets (0 - 65535) received from
the remote host since the most recent test was initiated
or completed.

Percent Lost

Shows the percent of ping test packets that were sent
with no response from the remote host since the most
recent test was initiated or completed.

RTT Min

Shows the minimum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.

RTT Max

Shows the maximum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.

RTT Average

Shows the average round-trip-time (RTT), from 0 to
4096 milliseconds, for packet transmission and
response.

Ping In Progress

Shows whether a ping test is in progress. 

Yes

 indicates

a test in progress, and 

No

 indicates that a test

completed or was not run.

Refresh

When viewing the ping test results, this item updates
the ping test data with current results. Select Yes to
update the data, or No to maintain the existing data.
However, a refresh automatically occurs when the
menu times out or you manually return to the main
menu.

Link Speed

 

 

The link speed and communication mode of the print
server must match the network. The available settings
depend on the device and installed print server. Select
one of the following link configuration settings:

If you change the link setting,

network communications with the print server
and network device might be lost.

Auto

 (default): The print server uses auto-negotiation

to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on
the detected link speed of the hub/switch port. (A
1000T half-duplex selection is not supported.)

10T Half

: 10 Mbps, half-duplex operation.

10T Full

: 10 Mbps, Full-duplex operation.

100TX Half

: 100 Mbps, half-duplex operation.

100TX Full

: 100 Mbps, full-duplex operation.

26

Chapter 2   Control panel

ENWW