Инструкции По Установке для Garmin GCV 10

To obtain the best performance and to avoid damage to your 

boat, you must install the Garmin

®

 transducer according to these 

instructions.
Read all installation instructions before proceeding with the 

installation. If you experience difficulty during the installation, 

contact Garmin Product Support.

Help us better support you by completing our online registration 

today.
• Go to 

.

• Keep the original sales receipt, or a photocopy, in a safe 

place.

• Go to 

for in-country support information.

• In the USA, call (913) 397.8200 or (800) 800.1020.
• In the UK, call 0808 2380000.
• In Europe, call +44 (0) 870.8501241.

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.
You are responsible for the safe and prudent operation of your 

vessel. Sonar is a tool that enhances your awareness of the 

water beneath your boat. It does not relieve you of the 

responsibility of observing the water around your boat as you 

navigate.

Failure to install and maintain this equipment in accordance with 

these instructions could result in damage or injury.
Always wear safety goggles, ear protection, and a dust mask 

when drilling, cutting, or sanding.

When drilling or cutting, always check what is on the opposite 

side of the surface.

You must copy the software update to a memory card.

Insert a memory card into the card slot on the computer.

Go to 

Select Download next to “Garmin Marine Network with SD 

card”.

Read and agree to the terms.

Select Download.

If necessary, select Run or save and open the file.

If necessary, select the drive associated with the memory 

card, and select Next > Finish.

Before you can update the software, you must obtain a 

software-update memory card or load the latest software onto a 

memory card.

Turn on the chartplotter.

After the home screen appears, insert the memory card into 

the card slot.
NOTE: In order for the software update instructions to 

appear, the device must be fully booted before the card is 

inserted.

Follow the on-screen instructions.

Wait several minutes while the software update process 

completes.
The device returns to normal operation after the software 

update process is complete.

Remove the memory card.
NOTE: If the memory card is removed before the device 

restarts fully, the software update is not complete.

• Drill and drill bits
• 7 mm wrench
• 3 mm hex wrench
• Number 2 Phillips screwdriver
• Masking tape
• Marine sealant

The transducer transmits and receives sound waves through the 

water, and relays sound-wave information to your Garmin sonar 

device.

Secure the mount 

À

 to the transducer 

Á

 with the included 

8 mm M4 screws 

Â

, 4 mm flat washers 

Ã

, and M4 split 

washers 

Ä

.

Secure the mount to the bracket 

Å

 with the included 12 mm 

M4 screws 

Æ

, M4 flat washers 

Ç

, and M4 lock nuts 

È

.

NOTE: You can use the 7 mm wrench to hold the lock nut in 

place while you tighten each 12 mm M4 screw.

October 2014

Printed in Taiwan

190-01681-02_0B