Справочник Пользователя для Ericsson UM10067

 

To ensure that PCI bus driver PCIBus.dll loads P1761 bus driver P1761Bus.dll, porting 
engineer should verify that the above-mentioned registry key matches with the PLX9054 
setting in the P1761bus.reg file located under directory ST-ERICSSON\PhISP176xBus. 

Once P1761Bus.dll is loaded and the system loads Host Controller stack P1761hcd.dll 
by checking registry setting in P1761bus.reg under directory ST-
ERICSSON\PhISP176xbus. 

This loading sequence will be different if you are working in GPIO mode. P1761Bus.dll 
will not be loaded in GPIO mode. 

As soon as Host Controller stack p1761hcd.dll is loaded, its platform dependent PDD 
code, system.c, (under ST-ERICSSON\PhISP176xHCD\PhISP176xPDD) gets the 
hardware resources, I/O port and interrupt ID, from the registry. These I/O port 
addresses are in the form of physical address. 

Direct hardware accesses by using the physical address from user mode device drivers 
or applications are prohibited by Windows. Physical addresses must be translated into 
virtual addresses using either MemMapIoSpace () or VirtualAlloc () / Virtual Copy. The 
translation can also be done by new Windows CE Ver. 5.0 function 
BusTransBusAddrToVirtual (). 

To build an image, select BuildOS -> Build and Sysgen. 

 

To create a boot floppy disk for an x86 SDB: 

1.  Navigate to the %ProgramFiles%\Windows CE Platform Builder\5.00\CEPB\Utilities 

directory, and then run WebSetup.exe to install utility programs to the default 
Microsoft Windows directory on your PC. You only need to install WebSetup.exe 
once. 

2.  On your PC, insert a blank 3.5-inch floppy disk in the floppy disk drive. 

 

UM10067_3 

© ST-ERICSSON. All rights reserved.