Справочник Пользователя для Echo EN55022

Echo LANlink Router Option User Manual

Issue 1.0

04 December 1997

Page 9 of 59

This section covers connection and set-up of the Echo LANlink Router
Option, and must be used in conjunction with the Echo LANlink User Manual.
If you are not familiar with the general configuration procedure for the Echo
LANlink, please refer to that manual before reading further and attempting to
configure the Router Option.

The Router is initially configured using an asynchronous terminal, or PC
using a suitable terminal emulation package such as Windows Terminal. The
terminal should be connected via its serial port to the SUPERVISOR port on
the rear of the Echo LANlink (see Echo LANlink User Manual).

The terminal should be configured as follows:

8 bit character, no parity, one stop bit, speed 9.6Kbps,

After power up, the terminal will display the following message:

Either type in the factory default login, mgr, or your login name if one has
previously been set and press <return>. The system will also prompt for a
password if one has been set - initially no password is required, but password
protection of the router configuration system is imperative to reduce the risk
of unauthorized changes. The set-up of a password is covered later.

The terminal will then display the following question.