Справочник Пользователя для Cyclades PM IPDU

When using the Cyclades PM IPDU independently of other Cyclades products, users and 
administrators may access the PM IPDU command line interface through a terminal emulation 
program by making a console connection from a local computer to the IN port on the PM IPDU. 
See To access the console: on page 21 for instructions. 

You may access the PM IPDU user interface by following the instructions provided in To access 
the console: on page 21. The menu that appears after connecting to the console depends on whether 
the PM IPDU has booted or not before you connect. 

If you connect to the console before powering up the Cyclades PM IPDU or reboot while 
connected, the Boot Menu appears.

If the PM IPDU has already booted before you connect to the PM IPDU through the console, the 
Login prompt appears.

On the Boot Menu, you may enter 

 (or just wait approximately 12 seconds) to select the Boot 

Firmware option. The Login prompt appears. 

If no PM IPDUs are daisy chained, the [PM]: IPDU: line appears only once, and the value is 1.

If there are any PM IPDUs daisy chained to the first PM IPDU, the [PM]: IPDU: line appears once 
for each PM IPDU in the chain. For each PM IPDU, the value is incremented by 1. The final 
appearance of the [PM]: IPDU: line will show the total number of PM IPDUs in the daisy chain.

If no PM IPDUs are daisy chained, the [PM]: OUT: line appears only once, and the value is equal 
to the number of outlets on the PM IPDU.

If there are any PM IPDUs daisy chained to the first PM IPDU, the [PM]: OUT: line appears once 
for each PM IPDU in the chain. For each PM IPDU, the value shows the cumulative total of outlets 
until the total number of outlets for the entire chain is displayed.