Справочник Пользователя для Crane Merchandising Systems Hot Beverage Maker 670
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001
Page - 91
November, 2002
TEST VARIOUS SENSORS AND SWITCHES
1. Press
, then press
until the display shows
IN.XXXXXX.
The X's in the display will be replaced by the following
place holders:
M K P H L 1
, defined as follows:
M = mug/cup sensor (if equipped) K = freevend keyswitch
P = waste pail switch
P = waste pail switch
H = high water tank level
switch
L = low water tank level switch
L = low water tank level switch
1/2 = ring 1/2 cup sensor
switch
2. Actuate each switch or sensor to test its function. As you actuate
each input, the display element representing that switch blinks on.
Releasing the switch causes that element to blink off again, and be
replaced by a dash.
each input, the display element representing that switch blinks on.
Releasing the switch causes that element to blink off again, and be
replaced by a dash.
3. CONTINUE.
PAYOUT COINS
1. Press
. If a dumb mech was selected, the display shows
NDQ
=
123
; if an MDB mech was selected the display shows
PAY
123
.
2. Press
. A dumb mech pays out one
N
ickel; an MDB mech
pays a coin from tube 1. Press
. A dumb mech pays out one
Dime; an MDB mech pays a coin from tube 2. Press
. A
dumb mech pays out one
q
uarter; an MDB mech pays a coin from
tube 3.
3. To continuously pay out coins, hold down the appropriate key.
3. To continuously pay out coins, hold down the appropriate key.
4. CONTINUE.